The sliding connection structure between the China LED Track Light Driver Box and the rail light is also very complicated

Track lights are lights installed on similar tracks. China 12w Magnetic Track Light can set the lighting angle as needed. Usually used as a spotlight where accent lighting is needed. Traditional track lights usually consist of a track, a power box and a light body. The sliding connection between the power box and the guide rail facilitates position adjustment. The lamp body is pivot ally connected to the power supply box to adjust the light angle.

It is believed that the sliding connection structure between the power supply box and the guide rail is also very complicated, difficult to disassemble and maintain, and expensive. Therefore, a magnetic connection structure is designed, that is, a magnet is installed in the power box, and an iron piece is installed on the corresponding guide rail to attract the magnet. After the magnet and the iron sheet are attracted, the frictional force is greatly increased due to the increase in the contact area, and the sliding adjustment is very troublesome, which is not conducive to rapid adjustment.

China Led Track System Magnetic Track Light usually use a built-in 24V low-voltage power supply, so they won't take up space. Even if the track is always energized, it is not dangerous to directly touch and install the light. At the same time, if the bulb is damaged, it is easy to repair. Just remove them for repair. Even a girl can change the lamp herself. Just put them in and they won't be as annoying as traditional light sources.

An easy-to-adjust DC Magnetic Track Lighting System, which consists of a track, a power supply box and a lamp body. The iron piece is installed in the guide rail. The power box is placed on the rail by a magnet, which can be attracted to the iron plate. Rotatable joints for power supply box and lamp body: two opposite inner side walls of the guide rail are respectively provided with front and rear sliding grooves, and connecting rods and rollers are provided on both sides of the iron sheet. The roller is located in the sliding groove and is firmly connected to the iron sheet by a connecting rod.